Change or rekey · Wilmot
Smart Lock Installation
You have just taken possession of the house and the previous owners handed over a keypad deadbolt with a code nobody wrote down and an app account you cannot get into.
In plain words
A smart lock is only half installed when the screws are tight; the other half is the account behind it. During the visit the administrator account is created by you, on your own phone and email, so nobody else holds the keys to the settings. Factory codes are deleted, a code is made for each person who needs one, and the auto-lock timing, sounds and alerts are set to suit the household. If the lock joins Wi-Fi or a hub, that connection is made and tested. The locksmith walks you through adding and removing users so future changes are yours to make, and keeps no codes afterwards.
How the visit goesHalf the evenings someone asks whether the back door got locked, and nobody is sure. A lock that relocks on its own, shows its state in an app and reports when it was last opened would settle the question.
Smart Lock Installation
How the visit goes
Who controls the door
A smart lock hands out access, so the visit begins by confirming who is entitled to grant it. For an owner that is photo identification and a link to the address; for a tenant it also means the landlord has agreed to the change, since in a rental both parties need a working way in. Where a property manager or a family member is arranging the work on someone else's behalf, the locksmith asks for that person's go-ahead as well. When a used smart lock is being taken over, the check extends to the account behind it, which must be released by whoever set it up. Ten minutes of paperwork here keeps everyone's access legitimate.
Taking over a lock that is already there
When the smart lock came with the house or with a rented unit, the work is a controlled handover rather than a physical fit. The locksmith follows the model's own reset procedure, usually a button sequence inside the interior cover, which wipes codes, schedules and paired phones. The lock is then enrolled to an account you create, and every hub, voice assistant or automation once allowed to unlock it is found and removed through its own account or app, since resetting the lock does not always clear those outside connections. Batteries are swapped for a fresh specified set, firmware is updated, the override cylinder is rekeyed, and the bolt is tested through the door as if it were new.
Keeping the lock healthy through the seasons
A smart lock asks for a little seasonal attention and rewards it. In spring and autumn, check that the bolt still glides with the door closed and no hand on it; a door that has swollen or dropped starts to strain the motor before it stops working, and a hinge screw or strike adjustment then is far easier than a call later. Keep the keypad free of ice and grit, wipe salt film off the exterior in winter, and use only a dry lubricant on the override cylinder, never oil. Accept firmware updates when the app offers them. If the lock starts to sound laboured, that is its way of asking for a look.
Smart Lock Installation
In the van
Mechanical override cylinder and repinning kit
Reinforced box strike with long screws
Door-position sensor magnet
Hole saw, spade bit and drilling jig
Adjustable-backset bolt and faceplate
Smart Lock Installation
What affects the quote
Number of doors
A single front door is the base case. Adding the back door, the garage entry or a side door, whether each gets its own smart lock or is rekeyed to match the override key, extends the visit accordingly.
Taking over an existing smart lock
Resetting, re-enrolling and cleaning the permissions on a lock that came with the property is a different job from fitting new hardware: less cutting, more account work, and it is quoted on its own footing.
Type of smart lock chosen
A keypad deadbolt, a Bluetooth model, a Wi-Fi model with a built-in radio or a lock that joins a home hub each sit at a different point on the hardware side of the quote, before any labour is counted.
What to have ready
- Should the door lock itself after it closes?
- Is there a storm door in front of it?
- What lock is on the door now: a separate deadbolt, a knob, a lever or a mortise lock?
Smart Lock Installation: questions
QuestionsWhat happens when the batteries die?
The lock warns you well before that point, with a light or tone at the keypad and, on connected models, a message to your phone. If the warnings are missed, a keyed model's mechanical override still opens the door, while a key-free model instead has two small contacts on the outside where a nine-volt battery gives it enough power to accept a code. The locksmith shows you each route your model offers and where the spare batteries and the key should live.
Does the lock still work if the internet goes down?
Yes for the things that matter at the door. Codes, fobs, fingerprints and the key talk to the lock directly, and schedules stored in the lock carry on, so you get in and out normally through a router reboot or an outage. What pauses is remote control from far away and the alerts, which return when the connection does. The locksmith will name exactly which features on your model need the network so there are no surprises.
Will the new lock match my existing door hardware?
Smart locks come in the same finish families as ordinary hardware: satin nickel, matte black, aged bronze, polished brass and chrome. The locksmith matches the finish to your handle set, or swaps the handle at the same time so the door reads as one piece. Where an old finish has weathered to a shade no new part will match, replacing the knob or lever alongside the deadbolt is the tidy answer, and the two are often sold as a matching pair.
Related services
- Deadbolt InstallationYou bought a keypad deadbolt online and pulled the old one off, only to find the hole in the door is a different size and the bolt latch sits at a backset the new kit does not list.
- Lock Replacement & UpgradeThree teenagers, a dog walker, a cleaner and one house key that keeps going missing.
- Vintage Mortise Lock ServiceSomeone painted the door years ago without removing the hardware.