Baden Lock Services · Wilmot
Ignition Lock Repair: what the visit covers
Locksmith · Wilmot, Ontario
A key that has snapped off inside the ignition barrel is not the end of the key, or of the barrel. The broken piece is drawn out with hooked or spiral tools built for the job, without pushing it further in, and the cylinder is checked afterward for the wear that likely caused the break in the first place. A fresh key is then cut and tested before the visit ends.
Mechanical fault or electronic fault
A cylinder that turns cleanly but leaves the vehicle silent makes a mechanical keyway fault less likely, though the cause can still be the immobilizer, the transponder chip, the wiring behind the switch, or an unrelated starting fault such as the battery, starter or park/neutral circuit. The locksmith checks whether the barrel physically moves through accessory, on and start, whether the steering lock disengages, and whether dash lights respond at each position. Where the mechanical side checks out cleanly, the remaining question is named and set aside as separate, dealer-level work rather than folded into the same repair.
Clearing grit, moisture and old grease
A barrel that has gone stiff from road salt, winter grit or years of old grease is opened, cleaned and treated with whatever lubricant the vehicle's own service instructions call for. Water that has found its way into the keyway is dried out fully before the cylinder is reassembled, so trapped moisture is not left sitting against the wafers to start the same problem again next season.
Knowing exactly what was done
You are told plainly whether the cylinder was serviced, repinned or replaced, whether anything else near the column was removed and refitted, and whether a broken key fragment came out along the way. Any part that was swapped is handed to you or set aside as you prefer, so nothing about the visit stays a mystery once the locksmith has packed up and left the driveway.